Winch how to get the maximum pull

Relatively easy drag can be used single-line, more difficult to use the pulley should be dragged with two-lane. Use a small load of the fromwinch electric winches for trucks or drag a particularly large load, you can even use three lines to obtain greater tension. Pull the capstan line out of the car and go back to the front of the car by the pulley on the tree-carrying belt, around the pulley on the trailer hook, and then back to the tree belt. This is the way to handle most of the winch , But keep in mind that this method will make your winch overload. With two or three lines, the cost of lifting the speed of the loss. Two-wire pull the car forward speed is half of the single-line, three-wire speed is one-third of the line. In addition to the multi-line mechanical principle, the reason for the greater pull force with two or three wires is that it is advantageous to pull the capstan wire from the drum more when using multiple wires, which is advantageous in that the inner Winch line than the outer layer has a greater pull, fromwinch electric wire winch on the subject of tension refers to the drum around the innermost layer of the line produced by the tension. The 12,000-pound capstan has a 6-ton pull on its lowermost layer, a 1,000-pound drop on each additional drum, and a 9-pound stretch on the outer drum. However, at least 5 turns must be left on the drum at all times, and pulling the fromwinch d shackle and bow shackle line all out will loosen the capstan line from the drum.